NorthStar 972 Quickstart Manual And Reference Manual page 83

page 76, you can add or remove waypoints
using the waypoints list as follows:
Adding waypoints to a route
Reference Manual Revision B
Editing a route using the waypoints list
1. Press the cursor pad to move the pointer at
the left side of the screen to the spot in
between two existing waypoints where you
want to insert a new waypoint.
(To add a waypoint to the beginning of the
route, be sure to position the pointer above
the first waypoint, not right onto it.)
Insert
2. Press to display the Select waypt
screen that lists all your stored waypoints. To
switch between the local and alpha lists,
Next view
press .
Note: you can't add an avoidance point to a
route.
3. Move the cursor to select the desired way-
point, then press ENTER to add the waypoint
to the route.
Removing waypoints from a route
1. Press the cursor pad to move the left-hand
pointer directly onto the waypoint you want to
remove.
Remove
2. Press
3. Press ENTER.
Erasing an entire route
To erase a route:
1. On the Routes screen, press the CURSOR
PAD to select the route you want to erase.
Erase
2. Press .
3. Press ENTER.
Editing a route you're navigating
along
When you follow a route, the route's
waypoints are copied to the navplan for
safekeeping. The navplan is displayed on
most chart screens and on the
screen.
If you change a route you're navigating
along, the 972 stores the changes, but they
won't appear in the navplan you're
following. To activate these changes in
your current navigation, you must start
following the route again.
If you edit the coordinates of a waypoint
directly in the navplan, you'll receive a
Reference section 5 — Creating waypoints and routes
.
Navlog
Editing a route
79