Table of Contents
Advertisement
3. SIGNALS AND WIRING
3.11 Servo amplifier terminal block (TE2) wiring method
(1) Termination of the cables
Solid wire: After the sheath has been stripped, the cable can be used as it is. (Cable size: 0.2 to 2.5mm
Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to
(2) Connection
Insert the core of the cable into the opening and tighten the screw with a flat-blade screwdriver so that
the cable does not come off. (Tightening torque: 0.3 to 0.4N m(2.7 to 3.5 lb in)) Before inserting the
cable into the opening, make sure that the screw of the terminal is fully loose.
When using a cable of 1.5mm
Use of a flat-blade torque screwdriver is recommended to manage the screw tightening torque. The
following table indicates the recommended products of the torque screwdriver for tightening torque
management and the flat-blade bit for torque screwdriver. When managing torque with a Phillips bit,
please consult us.
Downloaded from
ManualsNet.com
POINT
Refer to Table 14.1 in Section 14.2.1 for the wire sizes used for wiring.
avoid a short caused by the loose wires of the core and the adjacent pole. Do not solder
the core as it may cause a contact fault. Alternatively, a bar terminal may be used to put
the wires together.
Cable Size
2
[mm
]
AWG
For 1 cable
1.25/1.5
16
AI1.5-10BK
AI2.5-10BU
2/2.5
14
or less, two cables may be inserted into one opening.
2
To loosen.
To tighten.
Product
Torque screwdriver
Bit for torque screwdriver
search engine
Approx. 10mm
(0.39inch)
Bar Terminal Type
For 2 cables
AI-TWIN×1.5-10BK
Flat-blade screwdriver
Tip thickness 0.4 to 0.6mm
Overall width 2.5 to 3.5mm
Cable
Opening
Control circuit terminal block
Model
N6L TDK
B-30, flat-blade, H3.5 X 73L
3 - 34
Crimping Tool
Maker
CRIMPFOX ZA 3
or
Phoenix Contact
CRIMPFOX UD 6
Maker/Representative
Nakamura Seisakusho
Shiro Sangyo
2
)
Advertisement
Table of Contents
