Start-Up And Use; Before You Start; Using The Control Panel - ABB ACS560 Quick Installation And Start-Up Manual

R6...R8 1. Install the side plates (1a) of the cable box. Tighten the retaining screws (1b) with
32 EN - Quick installation and start-up guide
a screw driver.
2. Slide the cover (2a) of the cable box on the module from below until the cover
snaps into place.
3. Reinstall the module cover (3a). Tighten the two retaining screws (3b) with a
Frames Action
screwdriver.
1a
EN
Start up and use
HI
This section describes how to install and start-up the drive using the basic control panel.
Only limited information may be available in this manual. For detailed information of all
Menus and Sub menus, see the ACS-BP-S basic control panel user manual
(3AXD50000032527 [English]).
￭

Before you start

Make sure that the drive is installed as described in section
￭

Using the control panel

1. Clip – Press the clip downward to remove the
panel from the drive.
2. Display – Shows basic home view 1 by default.
See parameter 49.19 Basic panel home view 1.
3. RJ-45 connector slot – Located on the back side
of the control panel.
4. Back button – Moves back to the previous menus.
In the Home screen, this button navigates to the
Options menu.
5. OK button – Confirms the selected action.
6. Status LEDs –
• Continuous green – Indicates that drive is
functioning normally.
• Blinking green – Indicates an active warning in
the drive.
• Continuous red – Indicates an active fault in
the drive.
7. Arrow buttons – Allows scrolling up/down/left/right
on text pages. In the Home screen, the left and
right arrow buttons navigate to different (default or
user-defined) home screens (see parameter 49.19,
49.20 and 49.21).
8. Start button– Starts the drive.
9. Stop button – Stops the drive.
10. Loc/Rem button – Switches between Local/Re-
mote controls. Local control is through control
panel and Remote control is through PC or external
devices.
EN - Quick installation and start-up guide
1b
2a
21
3a
EN
3b
ES
Install the drive (page 5).
PL
TR
ZH