ABB ACS560 Quick Installation And Start-Up Manual page 140

Electrical installation
140 HI -त् व रित इं स ् ट ाले श न और स् ट ार् ट -अप गाइड
Refer to Electrical installation
wiring accordingly. The BIO-01 module has removable spring clamp terminals. Use
ferrules on the multistranded cables before assembly.
￭ BIO-01 विद् य ु त कने क ् श न
Sample wiring with the ABB standard macro:
Terminals
External sample connection
EN
HI
Start-up
￭ BIO-01 इं स ् ट ॉल करे ं
The BIO-01 module is automatically identified by the drive firmware. To configure the
By default, RIIO-01 module is provided in ACS560 standard R0...R2 drives. You can remove
inputs refer to the ACS480 firmware manual
the RIIO-01 module and can install BIO-01 and/or fieldbus adapter module (+Fxxx).
BIO-01 या / और फील् ड बस मॉड् य ू ल स् थ ापित करने के लिए, निम् न चरणों का पालन करे ं
1. सामने के कवर को हटा दे ं । हार् ड वे य र मै न ु अ ल मे ं अध् य ाय विद् य ु त स् थ ापना दे ख े ं
2. मौजू द ा RIIO-01 मॉड् य ू ल निकाले ं । निकाल दे न ा,
टिप् प णी
RIIO-01 मॉड् य ू ल मानक ACS560-01 R0 ... R2 ड् र ाइव मे ं डिफ़ ॉ ल् ट रू प से उपलब् ध है ।
a. लॉकिं ग पे ं च ढीला करे ं ।
b. लॉकिं ग टै ब को बाहर निकाले ं और RIIO-01 मॉड् य ू ल को अनलॉक करे ं ।
on page 55. If you configure the inputs, set up the
Description
Aux. voltage output and prog. digital input
+24V Aux. output +24 V DC, max. 200 mA
DGND Aux. voltage output common
DCOM Digital input common for all
DI1 Stop (0)/Start (1)
DI2 Forward (0)/Reverse (1)
Digital and analog I/O extension BIO-01
DI3 Constant frequency/speed selection
DI4 Constant frequency/speed selection
DI5 Ramp set 1 (0)/Ramp set 2 (1)
DO1 Not configured
AI1 Output frequency/speed ref: 0...10 V
+10V Ref. voltage +10 V DC (max. 10 mA)
GND Analog circuit common / DO common
SCR Signal cable shield / DO screen
Safe torque off (STO)
SGND Safe torque off. Factory connection.
Both circuits must be closed for the
IN1
drive to start.
IN2
OUT1
(3AXD50000047399 [English])
Base Internal connection
unit
X
X
X
X
X
X
X
X
X
.