ABB ACS560 Quick Installation And Start-Up Manual page 15

3. Connect the motor cable as follows:
If the power cable is temporarily removed from the grounding shelf, connect the
motor and input power cables except the 360 degree grounding, and then reinstall
the grounding shelf.
• Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (4a).
• Connect the twisted shield of the cable to the grounding terminal (4b).
• Connect the twisted shield of the cable to the grounding terminal (4b).
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W terminals.
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W terminals.
• Tighten the screws to the torque given below:
• Tighten the screws to the torque given below:
Frame size
Frame size
T1/U. T2/V. T3/W.
T1/U. T2/V. T3/W.
Note:
Notes
• The screws are of different length. Install them at correct locations.
• The screws are of different length. Install them at the correct locations.
• After reinstalling the grounding shelf, you can make the 360 degree grounding for the
• After reinstalling the grounding shelf, you can make the 360 degree grounding for
cables.
the cables.
Input power cable
Input power cable
4. Prepare the ends of the cable as illustrated in the figure.
4. Prepare the ends of the cable as illustrated in the figure.
Note:
The bare shield is grounded 360 degrees. Mark the pigtail made from the shield as a PE
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made from the
conductor with yellow-and-green color.
shield as a PE conductor with yellow-and-green color.
PE
PE
PE
PE
5. Connect the input power cable as follows:
R3
N·m
N·m lbf·ft
2.5...4.5 1.8...3.3
2.5...4.5
4c
4b
4a
EN - Quick installation and start-up guide 15
R3
R4
lbf·ft N·m
N·m lbf·ft
4.0 3.0
1.8...3.3 4.0
R4
lbf·ft
3.0
EN
HI