Mitsubishi Electric Fatec GOT2000 Series Basic Training Textbook page 82

(From previous page)
P O I N T
P O I N
When the target communication driver is not set, perform one of the following operations.
(1) Change the communication driver settings
(a) Touch the [Channel - Driver assign] button in the "Communication setting" screen.
(b) In the "Channel - Driver assign" screen, touch the [Change assignment] button.
(c) The communication drivers installed on the GOT are displayed. Select the target communication driver
and touch the [OK] button.
The GOT automatically restarts after this setting is executed.
If project data has been written to the GOT, the GOT starts monitoring a controller after the restart.
Execute this setting after carefully confirming the safety.
(2) Reinstalling the target communication driver using GT Designer3
If you do not find the target communication driver when performing the above operation, install it using GT
Designer3.
4 - 34
4. From GOT screen creation up to the test
4.5 Checking whether data has been properly transferred to the GOT
5.
In [Ethernet I/F assignment], check that the
Ethernet I/F setting of the channel No. 1 has
5.
been set to [Ethernet (standard I/F)].