Operation Check 1 - Mitsubishi Electric Fatec GOT2000 Series Basic Training Textbook

5.7 Operation check 1

Select [Communication] → [Write to GOT] from the menu to display the screen for writing project data.
Select data and a write mode, and then click the [GOT Write] button to write all data to the GOT.
Reset the PLC CPU using the RESET key switch, and then switch to RUN.
Check if each switch of the initial screen (No.1) functions properly here.
(1) Test 1
Perform the following tests in screen No. 1.
Item
Touch operation
Screen status
Write device
(2) Test 2
Perform the following tests in screen No. 1.
Item
*1
Touch operation
Screen status
Write device
Read device
*1 The line will not start when the operating time exceeds the planned operating time.
(3) Test 3
Perform the following tests in screen No. 1.
Item
Touch operation
Screen status
Write device
Read device
Test object
Touch the numerical input area.
When a key window screen appears, enter the numeric value (15), and then press
[Enter] of the key window.
D10
Test object
Line start switch
Touch
The switch is pressed.
M10: ON
────
Test object
Line stop switch
It is touched while the
operation lamp is on.
The switch is pressed.
M10: OFF
────
Planned operating time (numerical input)
RUN lamp
────
The lamp is on till the
planned operating time.
────
Y7A: ON
RUN lamp
────
The lamp is off.
────
Y7A: OFF
5. Drawing fundamentals
5.7 Operation check 1
Operating time
(numerical display)
────
Count up till the planned
operating time.
D20
────
Operating time
(numerical display)
────
Count stops.
────
D20
5 - 49
1
2
3
4
5
6