Mitsubishi Electric MELSEC-A0J2H Series Handbook page 174

10
REPLACING THE SPECIAL FUNCTION MODULE
(b) Functional comparisons
Item
Output HOLD/CLEAR
function
D/A conversion enable/
disable function
D/A output enable/ Specifies whether to output the D/A
disable function convertered value or the offset value.
Synchronous output
function
Programmable controller
CPU Analog output test
in STOP
Resolution mode
Online module change
10
- 11
A0J2-62DA
If programmable controller CPU is in stop
– state or an error has occurred, the output
analog value is retained.
D/A conversion can be set to be enabled or
–
disabled.
Output D/A conversion values can be set to
be output in batch, or output an offset value.
Synchronous analog output can be acquired
–
at the programmable controller CPU.
If CH output enable/disable flag at
programmable controller CPU STOP is forced
–
ON, D/A converted analog values will be
output.
Depending on the application, the resolution
– mode switches, and resolution of 1/4000, 1/
12000, or 1/16000 can be selected.
Module can be replaced without stopping the
–
system.
: Compatible, : Partially changed, ×: Incompatible
Compat-
Q62DAN
ibility
–
–
–
–
–
–
Precautions for
replacement
The CPU modules that
support the online module
change are a Process CPU
and a Redundant CPU.