Mitsubishi Electric MELSEC-A0J2H Series Handbook page 173

10
REPLACING THE SPECIAL FUNCTION MODULE
Item
Absolute maximum
Caution: With an output protection
output
circuit, the above voltage and
current output will not be exceeded.
Number of analog
output points
2
E PROM write count
Output short protection
Between the output terminal and
programmable controller power
Insulation method
supply: Photocoupler
Between channels: Non-isolated
Dielectric withstand
voltage
Insulation resistance
Number of occupied 64 points (I/O assignment: Special
I/O points
Connected terminal 36-point terminal block
Applicable wire size
(Applicable tightening torque
Applicable solderless V1.25-3 V1.25-YS3A
terminal V2-S3 V2-YS3A
5VDC internal current
consumption
Voltage 21.6 to 26.4VDC
External
Current
supply
consumption
power
Inrush
0.6A, 100ms (24VDC)
current
Weight
A0J2-62DA
Voltage ±12V
Current ±28mA
2 channels/ module
–
–
Between I/O terminal and programmable controller
Between output channels: Non-isolated
Between external supply power and analog output:
Between the I/O terminal and programmable controller
–
Between external supply power and analog output:
Between the I/O terminal and programmable controller
power supply: 500VDC 20M or greater
–
Between external supply power and analog output:
64 points) (I/O assignment: Intelligent 16 points)
2
0.75 to 2mm
39 to 59 N•cm)
(A solderless terminal with sleeve can not be used.)
0.55A
0.23A
0.75kg
: Compatible,
Q62DAN
Voltage ±12V
Current 21mA
Max. 100000 times
Available
power supply: Photocoupler
Non-isolated
power supply: 500VAC 1 minute
500VAC 1 minute
500VDC 20M or greater
16 points
18-point terminal block
2
0.3 to 0.75mm
R1.25-3
0.33A
24VDC +20%, -15%
Ripple, spike 500mV or less
P-P
0.15A
2.5A, 250µs or less
0.19kg
: Partially changed, : Incompatible
×
Compat- Precautions for
ibility replacement
Negative current output is
not allowed.
The number of I/O points
×
changes to 16.
×
×
Wiring change is required.
×
Peak current becomes
larger.
10
- 10