Mitsubishi Electric MELSEC-A0J2H Series Handbook page 124

7
PROGRAMS REPLACEMENT
(c) Setting procedure
1) To select
a) Set the drive/path to read by GPPQ and GPPA.
b) Set the system name and device name of the project to read using the [ Browse ] button.
c) Select by clicking the [ Param+prog ] button or [ Select all ] button, or using a mouse to place a
mark in the checkbox.
d) Click the [ Execute ] button after completing settings.
2) To cancel selected data
a) To cancel selected data arbitrarily
Remove the
b) To cancel all selected data
Click the [ Cancel all selection ] button.
(d) Precautions for reading other format files
A6GPP format,
SW0S-GPPA
format data
Selecting data
Reading in GPPA
format
Ladder return positions
For data selection
7
- 12
mark from the checkbox using the mouse or space key.
A series
Read data with GX Developer after performing the corresponding format conversion with
GPPA.
For details on how to proceed, refer to the SWSRXV/NX/IVD-GPPA GPP Function
Software Package Operating Manual (Details).
Only either Kanji or Kana comments can be selected for the device comments.
Abandons the project data of the GX Developer and reads other file formats.
The range exceeding the program capacity is deleted when reading.
If the microcomputer program, edited by programs other than an SFC program, such as
SW0SRX-FNUP is included, the program disappears.
QnA series
Returning places are different between GPRQ and GX Developer.
Because of this, if the total of return sources and return destinations exceeds 24 lines in a
single ladder block, the program is not displayed properly.
Corrective action: Add SM400 (normally on contact) to adjust the return positions.
For the device memory and file register, only one data name can be selected for each
item.