FusionDC1000A Prefabricated All-in-One Data
Center
Maintenance Guide (IT Scenario)
5.1 Repairing Pre-fab. Modules
Preparations
Tools: cutting machine, polishing machine, fine sandpaper, anhydrous alcohol,
cotton cloth, spray gun (for large area repainting), paint (epoxy zinc rich primer
+epoxy intermediate paint+polyurethane topcoat)
Material: steel plate for repair
Procedure
Step 1 Cut the damaged part into a regular rectangle.
Figure 5-1 Cutting the damaged part into a regular rectangle
Step 2 Use a polishing machine to polish the paint on the cut surface and ensure that the
polishing width is 10–20 mm.
Step 3 Cut the prepared material into the same size as the hole to be welded.
Step 4 Fully weld along the joints.
Issue 01 (2021-04-20)
Copyright © Huawei Technologies Co., Ltd.
5
Appendixes
5 Appendixes
169