Mitsubishi Electric Melsec Q Series Programming Manual page 210

4 MOTION SFC PROGRAMS
• Specifiable bit devices
Device
X
Y
M
U \G
CPU No. that is lager than the number of Multiple CPU cannot be set.
B
F
SM
(Note-1): The range of "PXn+4 to PXn+F" cannot be used (fixed at 0) for the input device
(PXn+0 to PXn+F) allocated to the built-in interface in Motion CPU (DI).
(n: First input No.)
(Note-2): "p" indicates the user setting area points of the Multiple CPU high speed
transmission area for each CPU.
POINT
Refer to Chapter 2 of the "Q173D(S)CPU/Q172D(S)CPU Motion controller
Programming Manual (COMMON)" for the user setting area points of the Multiple
CPU high speed transmission area.
Range
X0 to X1FFF
Y0 to Y1FFF
M0 to M12287
U \G10000.0 to U \G (10000+p-1).F
: CPU No. (No.1: 3E0, No.2: 3E1, No.3: 3E2, No.4: 3E3)
B0 to B1FFF
F0 to F2047
SM0 to SM2255
QDS
4 - 17
(Note-1)
(Note-2)