Ecc500 Network Fault - Huawei ECC500 User Manual

ECC500
User Manual

Procedure
Step 1 Check whether the communications cable between the ECC500 and the networked device is
disconnected.


Step 2 Check whether the parameters are correctly set for the networked device. For details, see
5.2.10 Adding a Networked


Step 3 Check whether the network is proper.


Step 4 Check whether the networked device is faulty.


----End

6.2.6 ECC500 Network Fault

Description
This alarm is generated when the ECC500 is disconnected from the network.
Attribute
Alarm ID
-
Impact on the System
After the alarm is generated, a short message is sent to the mobile phone of maintenance
personnel and prompt maintenance is required.
Possible Causes


Issue 05 (2020-03-16)
The networked device is faulty.
If yes, reconnect the communications cable.
If no, go to Step 2.
If yes, go to Step 3.
If no, reset the communications parameters.
If yes, go to Step 4.
If no, repair the network.
If yes, repair the networked device.
If no, contact Huawei technical support.
The communications cable is disconnected.
The ECC500 is faulty.
Copyright © Huawei Technologies Co., Ltd.
Device.
Alarm Severity
Warning
6 Maintenance and Troubleshooting
Alarm Type
Alarm
101