Setting An Ip Address For The Management Network Port - Huawei CX320 User Manual

CX320 Switch Module
User Guide
4.3 Setting an IP Address for the Management Network
Port
Set the IP address for the converged switching plane management network port on the
CX320.
The IP address of the management network port of the converged switching plane can be set
locally or on the MM910 as follows:
l
l
l
Prerequisites
Data
Table 4-3 Required data
Name
IP address, subnet mask, and
gateway of the converged
switching plane
management network port
Issue 09 (2019-08-02)
NOTE
Switch modules have a virtual serial port COM1. The virtual serial port is used by the built-in software
system in a switch module to manage the switch module. Note the following about the virtual serial port:
l Users cannot log in to the virtual serial port.
l The default password is Huawei#123.
l Do not set or change the virtual serial port login password; otherwise, some switch module functions
fail.
l If the login password is changed, run the undo authentication-mode or undo set authentication
password command to delete the new login password.
The IP address of the converged switching plane management network port can be set on
the MM910 WebUI. For details, see the procedure section in this topic.
On the converged switching plane CLI, run the ip address command to set the IP
address of the converged switching plane management network port. For details, see the
CX320 Switch Module Command
On the MM910 CLI, run the swipcontrol command to set IP address of the converged
switching plane management network port. For details, see
Module V100R001 Command
Copyright © Huawei Technologies Co., Ltd.
Reference.
Reference.
Description
You can log in to the
converged switching plane
CLI from a PC by using the
IP address of the
management network port.
4 Configuring the CX320
MM910 Management
Example Value
l IP address:
192.168.101.120
l Subnet mask:
255.255.255.0
l Gateway: 192.168.101.1
56