Adding An Abb Otm Ats - Huawei ECC500 User Manual

ECC500
User Manual
Parameter
Communication
Board COM
Equipment Address
Timeout
Step 4 Click Add Equipment.
----End
Follow-up Procedure
If the device addition fails, check whether the settings are consistent with the device
parameters.

5.2.8 Adding an ABB OTM ATS

Prerequisites



Context
After an ATS is connected to the ECC500, add the ATS on the ECC500 WebUI.
Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose Home > Equipment Manage.
Step 3 Select ATS from the Equipment Type drop-down list box and set device parameters, as
shown in
Issue 05 (2020-03-16)
Setting
Select 5 from the drop-down list box.
NOTE
In this example, set Equipment Address to 1. Set the actual
device address of the PDU8000 during operations.
The default timeout interval is 2s. Set the parameter to the required
value.
An ATS is connected to the ECC500. The ATS and ECC500 have been powered on.
You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.
You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
Figure 5-23. Table1 ATS parameters
Copyright © Huawei Technologies Co., Ltd.
The setting example indicates that the PDU8000 is connected to the COM5
port of the RS485 card in slot 3 of the ECC500. If the PDU8000 is
connected to another port, set the number of the connected port.
describes the setting methods.
5 UI Description
76