Adding A Ups5000-E - Huawei ECC500 User Manual

ECC500
User Manual
Table 5-3 UPS2000-G parameters
Parameter
Communication
Board Slot
Communication
Board COM
Equipment Address
Timeout
Step 4 Click Add Equipment.
----End
Follow-up Procedure
If the device addition fails, check whether the settings are consistent with the device
parameters.

5.2.4.2 Adding a UPS5000-E

Prerequisites



Context
After a UPS5000-E is connected to the ECC500, add the UPS5000-E on the ECC500 WebUI.
Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose Home > Equipment Manage.
Step 3 Select UPS from the Equipment Type drop-down list box and set device parameters, as
shown in
Issue 05 (2020-03-16)
Setting
Select 3 from the drop-down list box.
Select 2 from the drop-down list box.
In this example, set Equipment Address to 1. Set the actual
device address of the UPS2000-G during operations.
The default timeout interval is 2s. Set the parameter to the required
value.
A UPS5000-E is connected to the ECC500. The UPS5000-E and ECC500 have been
powered on.
You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.
You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
Figure 5-17. Table 5-4
Copyright © Huawei Technologies Co., Ltd.
describes the setting methods.
5 UI Description
67