Connecting An Ethernet Network Cable - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
Follow-up Procedure
Disconnection can be performed in reverse order.

4.10 Connecting an Ethernet Network Cable

Context


Procedure
Step 1 Connect one end of the delivered network cable to the Ethernet electrical port of a device.
Step 2 Connect the other end of the network cable to the ETH1 or ETH2 port of the SmartLogger,
as shown in Figure 4-34.
Figure 4-34 Connecting an Ethernet network cable
(2016-06-20)
The SmartLogger provides two Ethernet electrical ports, through which the SmartLogger
can connect to a third-party device.
The SmartLogger can be connected to an Ethernet switch, router, or POE module. It can
also be connected to the Ethernet electrical port of a PC directly or through a hub. Select
the connection device based on the actual networking scenario. For the typical
application scenarios, see Figure 2-6 and Figure 2-8 in 2.4 Typical Networking
Scenarios.
If the delivered cable is too short, pay attention to the following when preparing a cable:
Select CAT 5E or a higher-class shielded network cable.

The cable should not exceed 100 m in length.

A POE module can be connected only to the DATA port of the SmartLogger.

The default IP address of the SmartLogger is 192.168.0.10, the default subnet mask is 255.255.255.0,

and the default gateway is 192.168.0.1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Cables
65