Table of Contents
Advertisement
iBAT 2.0-CIM01C2
User Manual
Parameter
Battery N line
Single batt. group
number of HALL
Single batt. capacity
Batt. installation
time
iBAT number of
iBOX
Number of battery
strings
Batt. string No.
Parallel
Communication
Configuration
Modbus Config
HALL Rerverse
Config
Basic Information
Time
IP Address
Issue 07 (2019-01-02)
Description
Set whether there is a battery N wire according to the actual
situation.
Indicates the number of Hall effect sensors connected to a single
battery string.
Specifies the capacity of each battery that is connected in the battery
string in series.
Time when the battery is installed for the first time. Does not need
to be reset when part of batteries are replaced.
Indicates the total number of iBATs managed by the iBOX.
Indicates the total number of battery strings managed by the iBOX.
Sets the battery string numbers of the iBOXs connected in parallel
to unique ones when multiple iBOXs are connected in parallel.
This parameter needs to be set when multiple iBOXs are connected
in parallel and does not need to be set when there is only one iBOX.
Set Whether the iBOX communicates directly with the NetEco
to Yes, and set Number of iBOX configured under each UPS.
Configure IP addresses for multiple iBOXs.
Set ModbusTCP encryption and ModbusTCP authentication, which
are consistent with Connection Mode on the NetEco.
If the Hall effect sensor is reversely installed, you can set reverse
connection to correct it.
If a BCB box is configured, set BCB configuration to Done and
Batt. abnormal BCB trip to Enable.
Set the local time zone, date, and time.
Set the IP address, subnet mask, and default gateway of the iBOX.
Set this parameter based on the IP address assigned by the
administrator.
b.
On the iBOX WebUI homepage, choose System Settings > Battery Curve and set
the battery curve for each battery string.
c.
On the Battery Curve page, select the battery string to be set, set Battery Brand
and Format, click Filter > Submit.
Copyright © Huawei Technologies Co., Ltd.
5 System Commissioning
44
Advertisement
Table of Contents
