Huawei iBAT 2.0-CIM01C2 User Manual page 28

iBAT 2.0-CIM01C2
User Manual

The red terminal is positive, and the black terminal is negative. Connect battery terminals
correctly.

Voltages on the BIM cable are hazardous. Therefore, wear insulation gloves when
performing operations on the cable.

Check that there is no dust on the battery surface before attaching the BIM fastener to the
battery.

The BIM fastener is closely attached to the battery.
1.
Use an insulated torque wrench during battery installation. The terminal torque depends on
battery specifications.

M6: 4–6 N· m
 M8: 13–15 N· m

M10: 15–20 N· m
(1) Bolt
(4) OT terminal
2.
Issue 07 (2019-01-02)
Connect the positive and negative BIM cables respectively to the positive and negative
wiring terminals or poles of the battery.
Figure 3-3 Connecting battery cables
Install a battery bolt in the following sequence: bolt > spring washer > flat washer > OT terminal >
battery connecting piece.
Secure the BIM.
Copyright © Huawei Technologies Co., Ltd.
(2) Spring washer
(5) Battery connecting piece
3 Installing Devices
(3) Flat washer
22