Installing Equipment (Battery Rack) - Huawei iBAT 2.0-CIM01C2 User Manual

Hide thumbs Also See for iBAT 2.0-CIM01C2:

Table of Contents

iBAT 2.0-CIM01C2

User Manual

----End

3.3 Installing Equipment (Battery Rack)

Context

In the left figure, the CIM is installed at the top of the BCB box. In the right figure, the CIM

is installed at the side panel of the BCB box.

Figure 3-8 Installation positions of CIMs in the BCB box

(1) Hall effect sensor



In the left figure, the BIM is installed at the top of a battery. In the right figure, the BIM is

installed at the side panel of a battery.

Issue 07 (2019-01-02)

Dimensions (L x W) of the center hole of the Hall effect sensor are 40.5 mm x 30.5 mm

(LEM) or 40.5 mm x 40.5 mm (TAMURA).

If the battery string is configured with the neutral wire, measure the currents of the

positive and negative battery string cables. If the battery string is not configured with the

neutral wire, measure the current of either the positive or negative battery string cable.

The following uses the scenario where the battery string is configured with the neutral

wire as an example.

(2) CIM

3 Installing Devices

(3) BIB

Table of Contents