8.4.2
Communication detail settings
Item
Set this item when change the transmission speed used for communication with the
Transmission Speed
connected equipment.
(Default: 9600bps)
Set this item when change the data length used for communication with the connected
Data Bit
equipment.
(Default: 8bits)
Specify the stop bit length for communications.
Stop Bit
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed during
Parity
communication.
(Default: Even)
Set whether or not to perform a sum check during communication.
Sum Check
(Default: No)
Set the number of retries to be performed when a communication error occurs.
Retry
(Default: 0time)
Timeout
Set the time period for a communication to time out.
Time
(Default: 3sec)
Specify the host address (station No. of the GOT to which the temperature controller is
Host Address
connected) in the connected network.
(Default: 1)
Set this item to adjust the transmission timing of the communication request from the
Delay Time
GOT.
(Default: 5ms)
Select the communication format.
(Default: 1)
Format 1:
Format
Accessible to GREEN/UT100/UT2000/UTAdvanced Series
Format 2:
Accessible to GREEN/UT2000/UTAdvanced Series, Not accessible to UT100 Series.
POINT
POINT
POINT
(1) Format
(2) Communication interface setting by the Utility
(3) Precedence in communication settings
Description
• When connecting to UT100 Series, specify the format 1.
• When connecting to only GREEN/UT2000/UTAdvanced Series, specifying the format 2 is
recommended.
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Range
4800bps,
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
Done, None
0 to 5times
1 to 30sec
1 to 99
0 to 300ms
1/2
8.4 GOT Side Settings
8
8 - 35