Mitsubishi Electric GOT2000 Series Connection Manual page 126

Graphic operation terminal (non-mitsubishi electric products 2)

Hide thumbs Also See for GOT2000 Series:

Table of Contents

(3) Connecting terminating resistors

• For GT27, GT25(Except GT2505-V), GT23

Set the terminating resistor setting switch of the GOT main unit to "Enable".

• For GT2505-V, GT21, GS

Set the terminating resistor selector to "330Ω".

Since the terminating resistor is fixed to 330 Ω, no setting is required for the terminating resistor.

For the procedure to set the terminating resistor, refer to the following.

FUJI PLC side

When connecting a FUJI PLC to the GOT, a terminating resistor must be connected.

4.2 Serial connection

1.4.3Terminating resistors of GOT

4.2.7 PLC Side Setting

Chapters

Table of Contents