Plc Side Setting (Micrex-Sx Sph) - Mitsubishi Electric GOT2000 Series Connection Manual

4.3.3

PLC side setting (MICREX-SX SPH)

■1. Setting the IP address and self port reference No.
Set the IP address and self port reference No. using a peripheral tool of the PLC.
Item
*1
IP Address
Subnet Mask
Default Gateway IP Address
*2
Self port reference No.
*1 Adjust the settings with GOT settings.
➠
*2 Make sure that "Self port reference No. + 251" is equivalent to the port No. in the GOT.
➠
4.4 Device Range that Can Be Set
The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
be monitored.
■1. Setting item
(1) For FUJI MICREX-F
Item
Device
Information
Network
POINT POINT POINT
FUJI PLC
For details of FUJI PLCs, refer to the following manuals.
➠ FUJI PLC user's Manual
4.3.2 ■4. Connected Ethernet Controller Setting
4.3.2 ■4. Connected Ethernet Controller Setting
Set the device name, device number, and bit number.
The bit number can be set only when specifying the bit of word device.
The uppermost bit is b0 and the lowermost bit is b15.
Displays the device type and setting range which are selected in [Device].
Set the monitor target of the set device.
Station No. Select this item when monitoring the PLC of the specified station No.
Set value
[ ].[ ].[ ].[ ] PLC side IP address
[ ].[ ].[ ].[ ]
[ ].[ ].[ ].[ ]
PLC side setting
0 to 65280
Information
4.4 Device Range that Can Be Set
Range
4 - 35
4