Plc Side Setting (Micrex-Sx Sph) - Mitsubishi Electric GOT2000 Series Connection Manual

4.3.3

PLC side setting (MICREX-SX SPH)

■1. Setting the IP address and self port reference No.
Set the IP address and self port reference No. using a peripheral tool of the PLC.
Item
*1
IP Address
Subnet Mask
Default Gateway IP Address
Self port reference No.
*1
*2
4.4 Device Range that Can Be Set
The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
be monitored.
■1. Setting item
(1) For FUJI MICREX-F
Item
Device
Information
Network
4 - 34
4.4 Device Range that Can Be Set
POINT POINT POINT
FUJI PLC
For details of FUJI PLCs, refer to the following manuals.
➠
FUJI PLC user's Manual
*2
Adjust the settings with GOT settings.
➠
4.3.2 ■4. Ethernet setting
Make sure that "Self port reference No. + 251" is equivalent to the port No. in the GOT.
➠
4.3.2 ■4. Ethernet setting
Set the device name, device number, and bit number.
The bit number can be set only when specifying the bit of word device.
The uppermost bit is b0 and the lowermost bit is b15.
Displays the device type and setting range which are selected in [Device].
Set the monitor target of the set device.
Station No.
Set value
[ ].[ ].[ ].[ ]
[ ].[ ].[ ].[ ]
[ ].[ ].[ ].[ ]
0 to 65280
Information
Select this item when monitoring the PLC of the specified station No.
Range
PLC side IP address
PLC side setting