ABB i-bus KNX Product Manual page 91


ABB i-bus KNX
Commissioning
Enable function staircase lighting
Options:
With this parameter, the lighting group can be enabled for the function Staircase lighting.

no: For the lighting group no function Staircase lighting is available.

yes: For the lighting group the function Staircase lighting is available. The special properties of the
function Staircase lighting are set for the lighting group in
page 90. As there is only a timed progress in the DLR/A for the function Staircase lighting, the times
for the staircase lighting progression are activated in the
activated function Staircase lighting, the lighting group is switched on, and after a defined time it is
automatically switched off or dimmed down slowly as a warning. The basis brightness is the
brightness, to which the lighting group is set after the staircase lighting time has elapsed. This basis
lighting time may also be not equal to zero.
Note
The function Staircase lighting is comprised of two scenes. The DLR/A automatically selects the internal
scenes 13 and 14 when the function Staircase lighting is selected.
For further information see:
no
yes
Example
This function can ensure, e.g. that a basis brightness level always exists in the hallways in
nursing homes or hospitals. Maximum brightness is only activated when someone enters the
hallway (detected by a presence detector). It is dimmed down automatically to the basis
brightness, after the staircase lighting time has timed out and when nobody is in the hallway.
The setting of a warning before the function Staircase lighting switches off is possible using
dimming down. Optionally the warning can be displayed via an additional communication object,
see parameter Enable additional function 1/2.
Staircase
Parameter window
lighting, page 163
Parameter window - Gx Staircase
General, page 40. With
DLR/A 4.8.1.1 | 2CDC507128D0202 89
lighting,