ABB i-bus KNX Product Manual page 123
Dali-light controller dlr/a 4.8.1.1
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (182 pages) ,
- Product manual (152 pages)
Table of Contents
Advertisement
ABB i-bus
KNX
Commissioning
No.
3
This communication object is always enabled and indicates if the additional functions (Light control or Slave) are operating.
Bit value:
Bit 0 contains the information of the lighting group 1, bit 7 contains the information concerning the status of the additional
function of lighting group 8.
The example clarifies the interpretation of the communication object:
The example here is of a 2 byte communication object. The value read from the communication object, e.g. 34 (= 2
complies with the binary code below. 34 (= 2
This means that for lighting groups 6 and 2 an addition function (Lighting control or Slave) is activated for each and that
they operate.
4
This communication object is enabled if in
set with the option yes.
Should the light controller supply voltage fail for more than one to two seconds, an error message telegram is immediately
sent should sending a telegram at a change be parameterized.
Telegram value:
Function
Status additional function
0 = Additional function not operating
(Slave not following its master. The brightness of the controller lighting group does not
automatically follow the control)
1 = Additional function operating
(Slave following its master. The brightness of the controller lighting group automatically follows
the control)
15
14
13
12
11
2
2
2
2
2
0
0
0
0
0
Fault controller supply
Parameter window
0 = no fault
1 = fault
Object name
General
5
1
+ 2
).
10
9
8
7
6
5
2
2
2
2
2
2
0
0
0
0
0
1
General
General, page 40, the parameter Fault controller supply is
Data type
Flags
2 byte
C, R, T
non DPT
4
3
2
1
0
2
2
2
2
2
0
0
0
1
0
1 bit
C, R, T
DPT 1.005
DLR/A 4.8.1.1 | 2CDC507128D0202 121
5
1
+ 2
)
Advertisement
Table of Contents
