Table of Contents
Advertisement
Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
III. Connecting Power Cables to the Power Distribution Cabinet
Caution:
If the power supply is on during the operation, do not touch the binding posts with
the adjustable wrench or the screwdriver. Make sure to wrap the wrench with
insulating tape.
The installation of all lugs is the same.
To connect the power cable to the power distribution cabinet, proceed as follows:
1)
Connect the OT terminal of the power cable to the corresponding binding post on
the power distribution cabinet.
2)
Add common washers and spring washers, as shown in Figure 4-13.
(3)
(1) Cable
(4) Washer
Figure 4-13 Fixing the power cable
3)
Fix the lugs.
When several OT terminals of power cables must be connected to a binding post,
the lugs must not be overlapped. Connect them in a cross manner or
back-to-back mode, as shown in Figure 4-14.
If overlapping cannot be avoided, bend the lugs at an angle of 45 degrees or 90
degrees and put the bigger lug under the smaller one, as shown in Figure 4-14.
(1)
(4)
(5)
(2) Screw cap
(5) Spring washer
Huawei Technologies Proprietary
4-17
Chapter 4 Installing Cables
(2)
(3) Wiring screw rod
Advertisement
Table of Contents
