Table of Contents
Advertisement
Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
I. Positioning the Cabinet and Removing the Floor
Caution:
When positioning the cabinet, try to avoid the interference between the installation
supports and the antistatic floor framework. Keep the framework intact.
If the interference is unavoidable, remove the floor framework at the place where
the interference occurs during the installation. Align the first cabinet with the floor
edge.
To position the cabinet and remove the floor framework, proceed as follows:
1)
Determine the installation position of the cabinet according to the positioning
dimensions specified in the project design and construction blueprint.
2)
Place the lower support on the floor according to the cabinet layout.
3)
Mark the positions of four connecting holes of the cabinet (Each cabinet has four
connecting holes).
4)
Remove the lower support.
Use the φ20 bit to drill holes through the marked places. See section 2.4.2 II.
5)
"Drilling Holes and Installing Expansion Bolts" for details.
6)
Remove the antistatic floor for installation using a special tool (for example,
panel lifter).
7)
Remove strutting pieces for the antistatic floor.
II. Locating the Support at the Side of Antistatic Floor
Note:
Install the support according to Figure 2-12. Align the connecting holes at the outer
side of the support with the floor holes to prevent the support extruding out of the
cabinet.
Huawei Technologies Proprietary
2-13
Chapter 2 Installing Cabinet Assemblies
Advertisement
Table of Contents
