Table of Contents
Advertisement
Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Figure 2-12 Connection between support connecting holes and floor holes
III. To locate the support at the side of antistatic floor, proceed as follows:
1)
Place the support below the antistatic floor.
2)
Align the connecting holes of the support with the holes on the antistatic floor.
3)
Take the installation hole of the support as the template. Mark positions for the
expansion bolts on the concrete floor.
Use a Φ16 drill bit to drill holes at the marked places. Details about the drilling
4)
are available in section 2.4.2 I. "Positioning the Cabinet".
5)
Install expansion bolts by following the instructions in section 2.4.2 II. "Drilling
Holes and Installing Expansion Bolts".
6)
Finely adjust the height-locking bolts on the upper support until they do not slip
down by themselves.
7)
Put the support back to its installation position. Run the expansion bolt through
the installation hole of the support.
Huawei Technologies Proprietary
2-14
Chapter 2 Installing Cabinet Assemblies
Advertisement
Table of Contents
