Tx Input Command Delay; Tx Input Command Prolongation - ABB ETL600 Instruction Manual

ABB Switzerland Ltd
Local Command
at G4AI Input
Local Command
with Tx Input Delay
Local Command
with Tx Input
Prolongation
Remote Command
as received of TPE
(DSP on P4LT)
Remote Command
with fixed Rx Output
Duration at G4AI Output
Remote Command
with Rx Output Prolon-
gation at G4AI Output
Fig. 3-43
3.6.8.6.2.

Tx Input Command Delay

Note:
For some special applications a "pick up time" for the command inputs
has to be configured. A command is transmitted only after the
corresponding command input was activated for a preset delay time.
The preset input command delay is configurable for each command
separately by means of the HMI600 in the range of 0 ms (default
setting) to 10 ms.
The command sending duration is automatically prolonged by the
same time (compensation of the input command delay).
3.6.8.6.3.

Tx Input Command Prolongation

A Tx command prolongation ensures a steady tripping signal at the RF
output even in the event of discontinuations of the command(s) being
injected at the G4AI input(s).
A Tx command prolongation can be programmed for each command
separately in the range of 0 ms (default setting) to 3 seconds.
3-78
1KHW001489-EN
e.g. 5 ms
T0, e.g. 10 ms
Input/output command handling parameters
To configure an input command delay has a direct
influence on the transmission time of the equipment.
It is delayed correspondingly and thus means an
artificial deterioration of the equipment performance.
Normally the receiver at the remote station decides
whether it was a genuine command of adequate
length or only a transient spark on a command input.
Therefore the command inputs are not delayed per
default setting.
November 2005
e.g. 20 ms
e.g. 150 ms
e.g. 30 ms
Structure and Function
ETL600