ABB ETL600 Instruction Manual page 356

ETL600 Commissioning Report
Test
No. Test procedure
PAX-BLOCKING normal Measure at terminal,
PAX-BLOCKING
blocked
Interrupt local loop, wait
about 30 sec.
C.11.7 Transit mode for
E&M wire
Test E-Wire:
Close and open at
Remote equ. at terminal,
telephony 4a-4b
C.11.8 Testing the
teleoperation ports
C.11.9 Teleoperation AF1, if
not used for telephony
Fed input level, [dBm],
@ 800 Hz at AF1-IN
N11: ___________±1
N22: ___________±1
N34: ___________±1
N54: ___________±1
N65: ___________±1
C.11.10 Teleoperation AF2
Fed input level, [dBm],
@ 800 Hz at AF2-IN of
remote.
N11: ___________±1
N22: ___________±1
N34: ___________±1
N54: ___________±1
N65: ___________±1
© ABB Switzerland Ltd
Revision:
Test point
6a-6b is open
telephony 6a-6b,
6b-7a is closed
6b-7a
Measure at terminal, 6a-6b is closed
telephony 6a-6b,
6b-7a is open
6b-7a
Mark if configured:
Terminal, telephony E-Wire must toggle
3a-3b
Mark if configured:
Expected Output
level at AF1-OUT
Feed into terminal,
telephony 1a-1b
Measure at terminal,
telephony 2a-2b
Ext. Boost not active.
Mark if configured:
Expected Output
level at AF2-OUT
Feed into terminal,
teleop. 3a-3b
Measure at terminal,
teleop. 4a-4b
ext. Boost not active.
Language: Page:
EN C8/C10
Permissible
value Units
dBm
N11: _______±1
(600 Ω)
N22: _______±1
N34: _______±1
N54: _______±1
N65: _______±1
dBm
N11: _______±1
(600 Ω)
N22: _______±1
N34: _______±1
N54: _______±1
N65: _______±1
HE
Test
result
N11 N22
[ ] [ ]
N11 N22
[ ] [ ]
N11 N22
[ ] [ ]
N11 N22
[ ] [ ]
N11 N22 N34 N54 N65
[ ] [ ] [ ] [ ]
Measured Output level
at AF1-OUT
N11: ___________
N22: ___________
N34: ___________
N54: ___________
N65: ___________
N11 N22 N34 N54 N65
[ ] [ ] [ ] [ ]
Measured Output level
at AF2-OUT
N11: ___________
N22: ___________
N34: ___________
N54: ___________
N65: ___________
Form 1KHw001495-EN
N54
[ ]
N54
[ ]
N54
[ ]
N54
[ ]
[ ]
[ ]
Rev. A