ABB ETL600 Instruction Manual page 225

ETL600
10. If required, synchronize the trip counters in local and remote
stations by resetting them via HMI600 (menu Equipment /
Commissioning and maintenance / Event recorder / Reset
counter -> reset all counters).
c) Checking the entire link:
If a defect cannot be located with the help of the above tests, the
procedure
'Commissioning Instructions' available in the annex of this instruction
manual must be repeated for the units at both ends of the line.
Refer to section 9.6 for the causes of alarm messages displayed by
HMI600 after uploading equipment status and appropriate steps to be
taken.
Note:
Operation and Maintenance
1KHW001489-EN
for commissioning
Replace any modules found to be faulty. Repairing
modules on site is not recommended.
ABB Switzerland Ltd
NSD600 described
November 2005
in the
8-9