Integration In The I-Bus; Tool - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
General
1.2.3

Integration in the i-bus

The device possesses an interface to the i-bus
The i-bus
In addition, sensor data can be simulated for test purposes. If there is no communication, no output values
(measured values, thresholds) can be sent to the bus, even if they were simulated using the i-bus
The output values are still sent to the bus if cyclical sending is selected.
The i-bus
system can be tested during commissioning without the need to connect a temperature sensor.
The i-bus
ETS is not required for the Software Tool. However, Falcon Runtime (version 1.6 or higher and version 1.8
or higher for Windows 7) must be installed to set up a connection between the PC and KNX.
A description of the functions can be found in the i-bus
®

Tool

®
Tool can be used to read out data and test functions on the connected device.
®
tool can be used to define temperature values via the communication object, so that the KNX
®
Tool can be downloaded for free from our website (www.abb.com/knx).
®
Tool.
®
Tool online help.
®
Tool.
FCA/S 1.x.x.1 | 2CDC508134D0202 9