ABB i-bus KNX Product Manual page 167

®
ABB i-bus KNX
Commissioning
Enable communication object
"Status Switch" 1-bit
Options:
Selection of option Yes.
No
Yes
Dependent parameters:
Send object value
Options: No, update only
On change
After request
After a change or request

No, update only: The status is updated but not sent.

On change: The status is sent when a change occurs.

After request: The status is sent when a request occurs.

After a change or request: The status is sent on a change or a request.
Object value of contact position
Options: 1 = closed, 0 = open
0 = closed, 1 = open
This parameter defines the communication object value of the switch status (Status switch).

1 = Closed, 0 = Open: A closed contact is represented by communication object value 1 and
an open contact is represented by the value 0.

0 = Closed, 1 = Open: A closed contact is represented by communication object value 0 and
an open contact is represented by the value 1.
Note
The contact position and thus the switch status can be the result of a series of priorities and
links.
FCA/S 1.x.x.1 | 2CDC508134D0202 165