Sticking Brakes; Worn Surface From Screws - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
7-9-32

Sticking Brakes

Sticking brakes may be caused by screws backing out of the caster body and contacting the rubber on
the caster wheel. This can be found on either the front or the rear brakes. Observe the rubber on the
wheel, if you notice worn surfaces in the inside of the rubber or notice debris, replace the caster.
Caster body screw (1) wearing inside of the caster wheel (2). Images are for reference only, the casters
CANNOT be serviced. See: Figure 7-205 "How to identify if screws are backing out of Caster Body" on
page 7-349.
7 - 348
PROPRIETARY TO GE
. 7
EV
Figure 7-204 Worn Surface from screws
Section 7-9 - Troubleshooting Tips
LOGIQ E9 P
ROPRIETARY
S M
ERVICE ANUAL