GE LOGIQ E9 Service Manual page 542

D 5180483-100, R
IRECTION
Table 7-97
3.
4.
PROPRIETARY TO GE
. 7
EV
Freeing the Z-Axis
Steps
Locate the area where the Z-Axis Gear is
jammed.
Position the blade of a pry bar into the
gap, behind the Drive Gear Assembly,
where the Z-Axis Gear has jammed. DO
NOT position the pry bar on the Drive
Gear.
NOTE: Make sure ALL cables or ANY
components that can be damaged are
clear before proceeding to Step 5, as the
pry bar should not pinch any cables or
break any components or parts (plastic).
Chapter 7 Diagnostics/Troubleshooting
LOGIQ E9 P
ROPRIETARY
Corresponding Graphic
area where the Z-Axis Gear is jammed
Z-Axis Gear (1) jammed below the lower,
front flange (2) of the Z-Mech Support
(picture from below Drive Gear Assembly)
S M
ERVICE ANUAL
7 - 339