Basic Infeed Open-Loop Control - Siemens SINAMICS S120 Function Manual

Overview of key parameters for Basic Infeed (see List Manual)
S r0002
S r0046
S p0210
S p0840
S p0844
S r0898
S r0899
S r2138
S r2139
Function diagram overview (refer to the List Manual)
S 8720
S ...
S 8760
1.3.2

Basic Infeed open-loop control

Description
The Basic Line Module can be controlled via the BICO interconnection by means
of terminals or the field bus. The operating status is indicated on the operating dis-
play r0002. The missing enable signals for operation (r0002 = 00) are mapped in
parameter r0046. The EP terminals (enable pulses) must be connected in accor-
dance with the Equipment Manual.
Acknowledge error
Errors that are still present but the causes of which have been rectified can be ac-
knowledged by means of a 0 –> 1 edge at the "Acknowledge error" (p2103.5) signal.
© Siemens AG 2006 All Rights Reserved
SINAMICS S120 Function Manual, 03/2006 Edition
Infeed/operating display
CO/BO: Infeed missing enable signals
Device supply voltage
BI: ON/OFF1
BI: 1st OFF2
CO/BO: Control word sequential control infeed
CO/BO: Status word sequence control infeed
CO/BO: Control word, faults/alarms
CO/BO: Status word, faults/alarms 1
Control word sequential control infeed
Messages and monitoring functions
Infeed
Basic Infeed
1-35