Parameter - Siemens SINAMICS S120 Function Manual

Basic Information about the Drive System

Parameter

5.1 Parameter
Parameter types
The following adjustable and visualization parameters are available:
S Adjustable parameters (read/write)
These parameters have a direct impact on the behavior of a function.
Example: Ramp-up and ramp-down time of a ramp-function generator
S Visualization parameters (read only)
These parameters are used to display internal variables.
Example: Current motor current
BICO output
Fig. 5-1
Parameter categories
The parameters for the individual drive objects (see 5.3) are categorized according
to data sets as follows (see 5.2):
S Data-set-independent parameters
These parameters exist only once per drive object.
S Data-set-dependent parameters
These parameters can exist several times for each drive object and can be
addressed via the parameter index for reading and writing. A distinction is made
between various types of data set:
– CDS: Command Data Set (refer to Section 5.2)
By parameterizing several command data sets and switching between them,
the drive can be operated with different pre-configured signal sources.
– DDS: Drive Data Set
The drive data set contains the parameters for switching between different
drive control configurations.
The CDS and DDS can be switched over during normal operation. Further
types of data set also exist, however these can only be activated indirectly by
means of a DDS switchover.
S EDS
S MDS
5-306
read (r ...)
"Normal"
read-only parameters
Parameter types
Encoder Data Set
Motor Data Set
Parameter
read/write (p ...)
BICO input "Normal"
read/write parameters
© Siemens AG 2006 All Rights Reserved
SINAMICS S120 Function Manual, 03/2006 Edition