Regional Tab; Call Progress Tones - Linksys SPA 900 Series Administration Manual

Chapter 5 Linksys IP Phone Field Reference

Regional Tab

This section describes the fields for the following headings on the Regional tab:
•
•
•
•
•
•
•

Call Progress Tones

Note None of the following parameters apply to the SPA901.
Field
Dial Tone
Outside Dial Tone
Prompt Tone
Busy Tone
Reorder Tone
Off Hook Warning Tone
Ring Back Tone
Call Waiting Tone
Firmware Version 5.1
Call Progress Tones, page 5-19
Distinctive Ring Patterns, page 5-20
Control Timer Values (sec), page 5-21
Vertical Service Activation Codes, page 5-22
Vertical Service Activation Codes, page 5-22
Outbound Call Codec Selection Codes, page 5-25
Miscellaneous, page 5-27
Description
Prompts the user to enter a phone number.
Defaults to 350@-19,440@-19;10(*/0/1+2).
Alternative to the Dial Tone. It prompts the user to enter an external phone number, as
opposed to an internal extension. It is triggered by a, (comma) character encountered in
the dial plan.
Defaults to 420@-16;10(*/0/1).
Prompts the user to enter a call forwarding phone number.
Defaults to 520@-19,620@-19;10(*/0/1+2).
Played when a 486 RSC is received for an outbound call.
Defaults to 480@-19,620@-19;10(.5/.5/1+2).
Played when an outbound call has failed or after the far end hangs up during an established
call. Reorder Tone is played automatically when <Dial Tone> or any of its alternatives
times out.
Defaults to 480@-19,620@-19;10(.25/.25/1+2).
Played when the caller has not properly placed the handset on the cradle. Off Hook
Warning Tone is played when Reorder Tone times out.
Defaults to 480@10,620@0;10(.125/.125/1+2).
Played during an outbound call when the far end is ringing.
Defaults to 440@-19,480@-19;*(2/4/1+2).
Played when a call is waiting. Defaults to 440@-10;30(.3/9.7/1)
Linksys IP Phone Administrator Guide
Regional Tab
5-19