Miscellaneous Line Key Settings; Line Key Led Pattern - Linksys SPA 900 Series Administration Manual

Business series voice system (lvs) ip phones
Hide thumbs Also See for SPA 900 Series:
Table of Contents

Advertisement

Chapter 5
Linksys IP Phone Field Reference
Field
Extension
Short Name
(Not applicable to SPA901)
Share Call Appearance
(Not applicable to SPA901)

Miscellaneous Line Key Settings

This section does not apply to the WIP310 wireless phone.
Field
SCA Line ID Mapping
SCA Barge-In Enable

Line Key LED Pattern

Line key LED colors are described in
None of the following parameters apply to the SPA901.
Note
This section does not apply to the WIP310 wireless phone.
Field
Idle LED
Firmware Version 5.1
Description
Select an extension to be used for this line key. Choices are:
One-line phone: 1 or disabled,
Four-line phone: 1, 2, 3, 4, or disabled.
Six-line phone: 1, 2, 3, 4, 5, 6, or disabled.
Defaults to 1.
A short label shown on the LCD display for Line key 1/2/3/4/5/6.
Yes indicates that Line Key 1/2/3/4/5/6 is a shared call appearance. Otherwise this call
appearance is not shared (in other words it is private).
Defaults to no.
Description
Specifies the shared call appearance line ID mapping. Choose Vertical First or Horizontal
First. Each LED can hold two calls and the first call on an LED makes it light up. Horizontal
first means the second call makes the same LED flash. Vertical first means the second call
lights up the next LED.
For example, if Extension 101 is assigned to two LEDs, and Vertical First is selected, the sec-
ond call on Extension 101 lights up the second LED. The third call makes the first LED flash,
and the fourth call makes the second LED flash.
If Horizontal First is selected, the second call on Extension 101 makes the first LED flash.
The third call lights up the second LED, and the fourth call makes the second LED flash.
Enables the SCA Barge-In.
Defaults to no.
"Line Key LEDs" section on page
Description
LED pattern during the Idle state, where the call appearance is not is in use and is
available to make a new call. Leaving this entry blank indicates the default value of c=g.
3-22.
Linksys IP Phone Administrator Guide
Phone Tab
5-31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents