Vlan Settings - Linksys SPA 900 Series Administration Manual

System Tab
Field
Secondary DNS
DNS Server Order
(Not applicable to SPA901)
DNS Query Mode
Syslog Server
Debug Server
Debug Level
Primary NTP Server
(Not applicable to SPA901)
Secondary NTP Server
(Not applicable to SPA901)

VLAN Settings

Note None of the following parameters apply to the SPA901.
Field
Enable VLAN
VLAN ID
Enable CDP
Linksys IP Phone Administrator Guide
5-8
Description
DNS server used by Linksys IP phone in addition to DHCP supplied DNS servers if
DHCP is enabled; when DHCP is disabled, this is the secondary DNS server.
Defaults to 0.0.0.0.
Specifies the method for selecting the DNS server. The options are Manual,
Manual/DHCP, and DHCP/Manual.
Do parallel or sequential DNS Query. With parallel DNS query mode, the Linksys IP
phone sends the same request to all the DNS servers at the same time when doing a DNS
lookup, the first incoming reply is accepted by the Linksys IP phone.
Defaults to parallel.
Specify the syslog server name and port. This feature specifies the server for logging
Linksys IP phone system information and critical events. If both Debug Server and Syslog
Server are specified, Syslog messages are also logged to the Debug Server.
The debug server name and port. This feature specifies the server for logging Linksys IP
phone debug information. The level of detailed output depends on the debug level
parameter setting.
The debug level from 0-3. The higher the level, the more debug information is generated.
Zero (0) means no debug information is generated. To log SIP messages, you must set the
Debug Level to at least 2.
Defaults to 0.
IP address or name of primary NTP server.
IP address or name of secondary NTP server.
Description
Enable this parameter if the switch to which the Linksys IP phone is connected uses
VLAN tagging.
Enter the VLAN tag for the VLAN to which the Linksys IP phone is assigned. This should
be the same VLAN to which the SPA9000 is assigned.
Enables or disables Cisco Discovery Protocol (CDP.
Defaults to Yes.
Chapter 5 Linksys IP Phone Field Reference
Firmware Version 5.1