Distinctive Ring Patterns - Linksys SPA 900 Series Administration Manual

Regional Tab
Field
Confirm Tone
SIT1 Tone
SIT2 Tone
SIT3 Tone
SIT4 Tone
MWI Dial Tone
Cfwd Dial Tone
Holding Tone
Conference Tone
Secure Call Indication Tone
Page Tone
Alert Tone

Distinctive Ring Patterns

None of the following parameters apply to the SPA901.
Note
Linksys IP Phone Administrator Guide
5-20
Description
Brief tone to notify the user that the last input value has been accepted.
Defaults to 600@-16; 1(.25/.25/1).
Alternative to the Reorder Tone played when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0).
Alternative to the Reorder Tone played when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/3,0/4/0).
Alternative to the Reorder Tone played when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)
This is an alternative to the Reorder Tone played when an error occurs as a caller makes
an outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 985@-16,1371@-16,1777@-16;20(.380/0/1,.274/0/2,.380/0/3,0/4/0).
Played instead of the Dial Tone when there are unheard messages in the caller's mailbox.
Defaults to 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2).
Played when all calls are forwarded.
Defaults to 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2).
Informs the local caller that the far end has placed the call on hold.
Defaults to 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Played to all parties when a three-way conference call is in progress.
Defaults to 350@-19;20(.1/.1/1,.1/9.7/1).
Played when a call has been successfully switched to secure mode. It should be played
only for a short while (less than 30 seconds) and at a reduced level (less than -19 dBm) so
it does not interfere with the conversation.
Defaults to 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2).
Specifies the tone transmitted when the paging feature is enabled.
Defaults to 600@-16;.3(.05/0.05/1).
Played when an alert occurs.
Defaults to 600@-19;.2(.05/0.05/1).
Chapter 5 Linksys IP Phone Field Reference
Firmware Version 5.1