Honda 2004 Odyssey Service Manual page 1075

Shafts and Clutches
Clutch Reassembly (cont'd)
22. Release the clutch end plate to lower it, then put the
special tool on the end plate (A).
B
A
D
23. Press the special tool down with 39 N (4 kgf, 9 lbf)
using a force gauge, and read the dial indicator
reads the clearance (B) between the clutch end
plate and top disc (C). Take measurements at least
three places, and use the average as the actual
clearance.
Clutch End-Plate-to-Top-Disc Clearance
Service Limit:
• 1st Clutch: 1.1 1.3 mm (0.043 0.051 in.)
• 2nd Clutch:0.85 1.05 mm (0.033 0.041 in.)
• 3rd Clutch: 0.7 0.9 mm (0.028 0.035 in.)
• 4th Clutch: 0.55 0.75 mm (0.022 0.030 in.)
• 5th Clutch: 0.55 0.75 mm (0.022 0.030 in.)
14-462
39N
(4 kgf, 9 lbf)
07ZAE-PRP0100
C
24. If the clearance is not within the service limit, select
a new clutch end plate from the following table.
NOTE: If the thickest clutch end plate is installed,
but the clearance is still over the service limit,
replace the clutch discs and plates as a set.
Replace the PCM, if 3rd clutch discs and plates
replacement is required.
1ST CLUTCH END PLATES
Mark Part Number
1 22551-P7W-003
2 22552-P7W-003
3 22553-P7W-003
4 22554-P7W-003
5 22555-P7W-003
6 22556-P7W-003
7 22557-P7W-003
8 22558-P7W-003
9 22559-P7W-003
2ND CLUTCH END PLATES
Mark Part Number
1 22551-PY4-003
2 22552-PY4-003
3 22553-PY4-003
4 22554-PY4-003
5 22555-PY4-003
6 22556-PY4-003
7 22557-PY4-003
8 22558-PY4-003
9 22559-PY4-003
Thickness
3.1 mm (0.122 in.)
3.2 mm (0.126 in.)
3.3 mm (0.130 in.)
3.4 mm (0.134 in.)
3.5 mm (0.138 in.)
3.6 mm (0.142 in.)
3.7 mm (0.146 in.)
3.8 mm (0.150 in.)
3.9 mm (0.154 in.)
Thickness
2.1 mm (0.083 in.)
2.2 mm (0.087 in.)
2.3 mm (0.091 in.)
2.4 mm (0.094 in.)
2.5 mm (0.098 in.)
2.6 mm (0.102 in.)
2.7 mm (0.106 in.)
2.8 mm (0.110 in.)
2.9 mm (0.114 in.)