Connecting With Keyboard Wedge - Honeywell Voyager 1200g User Manual

2. Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal
surface.
3. The scanner beeps.
4. Verify the scanner or base operation by scanning a bar code from the
The unit defaults to a USB PC Keyboard. Refer to
For additional USB programming and technical information, refer to "USB Application Note," available at
wellaidc.com.

Connecting with Keyboard Wedge

A scanner or base can be connected between the keyboard and PC as a "keyboard wedge," where the scanner provides
data output that is similar to keyboard entries. The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the terminal/computer.
2. Connect the appropriate interface cable to the scanner and to the terminal/computer.
3. Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal
surface.
4. Turn the terminal/computer power back on. The scanner beeps.
1 - 2
page 2-4
only if
power
supply is
included
Charge and
Communications Base
Keyboard Wedge
Connection:
Sample Symbols
for other USB terminal settings.
in the back of this manual.
www.honey-