1. Connect the appropriate interface cable to the scanner first, then to the computer.
2. Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal
surface.
3. The scanner beeps.
4. Verify the scanner or base operation by scanning a bar code from the
The unit defaults to a USB PC Keyboard. Refer to
For additional USB programming and technical information, refer to "USB Application Note," available at Technical Support
Knowledge Base (www.hsm.force.com/publickb.)
Connecting with Keyboard Wedge
A scanner or base can be connected between the keyboard and PC as a "keyboard wedge," where the scanner provides
data output that is similar to keyboard entries. The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the terminal/computer.
1 - 2
Charge and
Communications
Base USB
Connection:
optional
power
supply
page 2-4
Sample Symbols
for other USB terminal settings.
in the back of this manual.