Resetting The Custom Defaults - Honeywell Voyager 1200g User Manual

Resetting the Custom Defaults

If you want the custom default settings restored to your scanner, scan the Activate Custom Defaults bar code below. This
resets the scanner to the custom default settings. If there are no custom defaults, it will reset the scanner to the factory default
settings. Any settings that have not been specified through the custom defaults will be defaulted to the factory default settings.
Note: If using a cordless system, scanning this bar code also causes both the scanner and the base to perform a reset and
become unlinked. The scanner must be placed in its base to re-establish the link before any setup codes are entered.
See Cordless System Operation
1 - 6
Activate Custom Defaults
beginning on page 3-1 for additional information.