NAK Retries
This selection limits the number of NAK retries that can occur in ACK/NAK mode. Scan the bar code below, then set the
number of retries (from 0-255) by scanning digits from the
Programming
Chart, then scanning Save. (5 is the recom-
mended setting.) Default = 0, or disabled.
NAK Retries
Support BEL/CAN in ACK/NAK
This protocol responds to <BEL> and <CAN> commands when in ACK/NAK mode. The scanner sounds an error tone
when a <BEL> command is sent from the host. <CAN> terminates the transmission. Default = BEL/CAN Off.
BEL/CAN On
* BEL/CAN Off
RS232 Defaults
If you want the custom RS232 default settings restored to your scanner, scan the RS232 Defaults bar code below. This
resets the scanner to the custom default settings (see
Setting Custom Defaults
on page 1-5). If there are no custom
defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the cus-
tom defaults will be restored to the factory default settings.
RS232 Defaults
NCR Modifiers
NCR ACK/NAK
This is an NCR communication protocol for ACK/NAK processing. Default = NCR ACK/NAK Off.
* NCR ACK/NAK Off
NCR ACK/NAK On
2 - 27