Honeywell Voyager 1200g User Manual page 203

Reprogram the base/Access Point with the correct Plug and Play bar code. See
page 2-1.
• The bas or Access Pointe may not be programmed to output your bar code data properly. For example, you scan "12345"
and the host displays "A12345B."
Reprogram the base/Access Point with the proper symbology selections. See
The scanner won't read your bar code at all.
• Scan the sample bar codes in the back of this manual. If the scanner reads the sample bar codes, check that your bar
code is readable.
Verify that your bar code symbology is enabled (see
If the scanner still can't read the sample bar codes, scan
Chapter
Chapter 7).
All Symbologies on page 7-1.
Programming the Interface
7.
beginning on
12 - 5