Changing The Scanner's Bluetooth Pin Code; Minimizing Bluetooth/Ism Band Network Activity; Auto Reconnect Mode - Honeywell Voyager 1200g User Manual

To relink to the charge base, scan the Base BT Connection bar code.
Non-Base BT Connection

Changing the Scanner's Bluetooth PIN Code

Some devices require a PIN code as part of the Bluetooth security features. Your scanner's default PIN is 0000, which you
may need to enter the first time you connect to your non-base Bluetooth device. To change the PIN, scan the following bar
code and then scan the appropriate numeric bar codes from the
(The PIN code must be between 1 and 16 characters.) Scan Save to save your selection. Default = 0000.

Minimizing Bluetooth/ISM Band Network Activity

The following settings can help you customize the relinking behavior of the cordless system to obtain the best compromise
between convenience and low interference.
Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless networks, cordless phones, and Bluetooth.

Auto Reconnect Mode

Auto Reconnect controls whether or not the scanner automatically begins the relink process when a loss of connection is
detected. When the Auto Reconnect On bar code is scanned, the scanner begins the relink process immediately, without
user intervention. Default = Auto Reconnect On.
* Auto Reconnect On
The following table shows the results of the Auto Reconnect On and Off settings:
Event
Scanner out of range
Programming Chart
Bluetooth PIN
Auto Reconnect On
Relink occurs automatically. If maximum
number of link attempts is unsuccessful,
then the scanner must be relinked by
either pressing the scanner's button or
placing the scanner in the base. (See
"Maximum Link Attempts" on page 3-18.)
Base BT Connection
inside the back cover of this manual.
Auto Reconnect Off
Auto Reconnect Off
The scanner is relinked by pressing
the button.
3 - 17