Nak Retries; Support Bel/Can In Ack/Nak - Honeywell Voyager 1200g User Manual

Timeout Retries
This setting limits the number of Communication Timeout retries. If the Timeout Retries is set to 0, the transmission is
terminated after the initial Communication Timeout. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the
0.
Communication Timeout Beeper
This selection programs the scanner to issue an error beep when a communication timeout has occurred. The error
beep sound is programmed using

NAK Retries

This selection limits the number of NAK retries that can occur in ACK/NAK mode. Scan the bar code below, then set the
number of retries (from 0-255) by scanning digits from the
mended setting.) Default = 0, or disabled.

Support BEL/CAN in ACK/NAK

This protocol responds to <BEL> and <CAN> commands when in ACK/NAK mode. The scanner sounds an error tone
when a <BEL> command is sent from the host. <CAN> terminates the transmission. Default = BEL/CAN Off.
BEL/CAN On
2 - 6
Programming Chart, then scanning Save. (5 is the recommended setting.) Default =
Timeout Retries
Number of Beeps – Error
Programming
NAK Retries
(page 4-3). Default = On.
Chart, then scanning Save. (5 is the recom-
* On
* BEL/CAN Off